DIY Builds
Photo by JACK BROWN Pexels Logo Photo: JACK BROWN

Do all metal sheds get condensation?

All metal garden sheds will suffer from condensation where damp is present in the foundation. This occurs when a damp proof course has not been built into the base .

Can you span 12 feet with a 2X4?
Can you span 12 feet with a 2X4?

Depending on various factors, a 2×4 floor or deck joist can span a maximum of 6' 7” at 16” spacing or 7'11” at 12” spacing.

Read More »
Is a ramp safer than steps?
Is a ramp safer than steps?

A ramp is much safer and easier to use than stairs for anyone with any type of mobility issue. Think of the various people and equipment which may...

Read More »
Are shed plans easy to follow?
Are shed plans easy to follow?

These are! They guide you every step of the way to complete your dream shed.

Learn More »

Metal sheds are a fantastic alternative to having a wooden shed. They enable you to overcome many of the maintenance problems that you often encounter with timber structures. However as we’re all aware metal sheds themselves can suffer from condensation problems. Read on to find out how to alleviate this problem. All metal garden sheds will suffer from condensation where damp is present in the foundation. This occurs when a damp proof course has not been built into the base . Air inside a shed is slightly warmer than the air around it outside so any moisture in the foundations will rise until it touches the cool exterior metal panels and cools forming condensation. This moisture then will drip down and will become part of the cycle once more. Because condensation is so difficult to stop it is essential that you prevent damp in the first place by ensuring you take proper action when constructing the base of your shed. * Always make the concrete or slab base only a few inches larger than the base rail of the shed. * A damp proof membrane must be inserted into the foundations. It needs to be put into the base at least two inches higher than the surrounding ground level. * Allow the foundations of the shed to cure for 3-7 days after laying the concrete. Do allow longer if the conditions are damp. If you fail to do this the water drying up from the concrete will provide moisture to start a condensation cycle once your shed has been erected. * After you have bolted your metal shed to the concrete or slab base apply a silicone or mastic sealant to the inside of the shed base rails. (Please note it must be the inside and not the outside). By doing this you will preserve the drainage capacity of the channels whilst preventing any water seepage under the rails and into the shed. If you are reading this as you have already constructed your metal shed and are unfortunately now suffering from condensation here’s some of the best ways to break the condensation cycle and fix your problem:

Do rattlesnakes live in wood piles?
Do rattlesnakes live in wood piles?

Wood Piles are Common Rattlesnake Hiding Places. Aug 2, 2014

Read More »
Do rats dig under sheds?
Do rats dig under sheds?

Rats frequently burrow under houses and sheds for their warmth and proximity to food. Understanding the causes of an infestation and preventing...

Read More »

Detach your shed from its base and build a timber floor a few inches larger than the base measurements of the shed put this on raised bearers. Next fix the shed to the timber floor securing with wood screws and mastic seal the inside of the shed base rails. By doing this you are allowing air to flow under the floor enabling it to keep dry thus eliminating the problem. Please remember with this method to check that water cannot pool under the floor as this will stop the ventilation and render all of your hard work useless. An alternative tried and tested method of eliminating condensation from your metal garden shed is to clean off the underside of the roof panels with a methylated spirit making sure all panels are dry, then purchase polystyrene tiles and attach them onto the underside of the sheds roof using a specialist spray glue that bonds polystyrene to metal and is not affected by the hot or cold. It is best to carry out this work on a warm day. Both the tiles and the shed roof should be coated and after 2 minutes the surfaces can be bonded together. By using this method you will not be eradicating the moisture in the atmosphere within your shed however you will be able to prevent condensation now that your shed has been insulated.

For a great range of metal sheds visit Jacks Garden Store now.

Good Luck

Gardener Jack

At what temperature will concrete freeze?
At what temperature will concrete freeze?

MISTAKE #2: ALLOWING CONCRETE TO FREEZE Plastic concrete freezes at about 25° F and doing so can reduce its final strength by more than 50%....

Read More »
How do I keep rats out of my metal building?
How do I keep rats out of my metal building?

Strong odors like peppermint and cedar oil have long been used as deterrents for rodents, and these products are easy to apply around a metal shed...

Read More »
These are the Best Shed Plans!
These are the Best Shed Plans!

Comprehensive and Intuitive to follow. Build That Shed!

Learn More »
What is the natural predator of rats?
What is the natural predator of rats?

Famously, birds of prey feed on mice and rats. Raptors, including hawks, owls, eagles and falcons, are common predators. Red tail hawks, found...

Read More »
Are shed plans easy to follow?
Are shed plans easy to follow?

These are! They guide you every step of the way to complete your dream shed.

Learn More »
What are the disadvantages of a tiny house?
What are the disadvantages of a tiny house?

Disadvantages of Tiny Houses Less Living Space. A tiny house doesn't have room for a full-sized luxury kitchen or bathroom. ... Less Storage Space....

Read More »