Do I need bearers for a shed on concrete?

To ensure the floor stays dry, we strongly advise that bearers are used, even with concrete/paved bases as this allows air circulation and prevents the floor coming into contact with any water.

theshedcentre.com - Before you buy | The Shed Centre

How many batteries do I need for off grid solar?

If you want to keep the power on when the grid is down, you'll usually just need one solar battery. If you want to go off-grid completely, you'll...

Last updated May 8, 2021

Does more cement make concrete stronger?

To make the concrete stronger, add more cement or less sand. The closer you bring the ratio to an even one-to-one of sand to cement, the stronger...

Last updated Dec 21, 2020

These are the Best Shed Plans!

Comprehensive and Intuitive to follow. Build That Shed!

Learn More »

Promotion

Before you buy

Space around the shed

You should leave ample space, to be able to walk around the shed completely, allowing easy installation and more importantly allowing you to be able to preserve the shed annually

Base Preparation

There are three main ways to achieve a suitable shed base. You can either:

1. Construct a concrete base

2. Lay a base using paving slabs

Or for a much easier and cost effective way you can use a system called:

3. Bearers and slabs.

Bearers are 3″x3″ (75x75mm) pressure treated posts which run in an opposite direction to the floor joists making a crisscross formation, allowing good air circulation. For a concrete base you must make sure that the depth of the base you lay is no less than 4″ (100mm). For paved bases you should compact the surface, and bed the slabs onto sand and cement dry mix or gravel. With both the above base methods the area needs to be cleared of turf and foliage, you should use a membrane in the construction to stop damp rising up, but most importantly make sure the finished base is level, firm and square and no smaller than the size of the shed which you have ordered. To ensure the floor stays dry, we strongly advise that bearers are used, even with concrete/paved bases as this allows air circulation and prevents the floor coming into contact with any water. If you would like to order our bearers and slabs system, and we are installing the shed for you, the ground must be prepared prior to our arrival, all that is required is that the area is cleared of any foliage and no more than 4” (100mm) out of level over the whole area of the size of shed you have chosen. Our fixing teams will have packing to level out some unevenness but no more the than 4″ (100mm). As you can see from the below picture we only use a slab at each end of the bearer (and in the middle on 8’ (2.4m) and over), it is an unnecessary expense to slab anywhere else under the shed, the only purpose of the slab is to stop the bearer coming into contact with the soil/ground.

Access

Who is World No 1 guitarist?

Top 10 Best Guitarists of All Time Rank Guitarist Top Strength 1 Guthrie Govan All-Around Technical Virtuoso 2 Pat Metheny Jazz Voicing & Picking 3...

Last updated Apr 22, 2022

How long does IKEA particle board last?

Particle Board or MDF (Medium-Density Fiberboard) Interestingly, you will find that furniture that was built with particle board or MDF can last up...

Last updated Oct 29, 2020

Can I build my own shed?

Yes, with the right plans you can build your dream shed.

Learn More »

Promotion

Although the sheds are delivered in sections, some sections on certain sheds are very large and will not go through a house, garage or under a gateway if there is a height limit above e.g.; trellis, arch, branches, wires, pipes, bars etc, this is a common problem. If you have a limitation we can give you the sizes of the sections of your chosen building so that you can check if it will fit under your limit. If you have a limitation, to overcome this problem we are able to make your chosen shed in smaller sections, please contact us prior to ordering. This service carries an additional cost.

Treatment

All buildings are pre-treated with a quality water-based wood preservative prior to delivery. We recommend a topcoat upon installation, using a good quality preservative like: Cuprinol Garden Wood Preserver, which is spirit-based.

Delivery

Once you have placed your order with us, you will receive a courtesy call to arrange a delivery date.

Installation

As we have mentioned previously, the buildings that we sell are of high quality and excellent construction, therefore they are user friendly, and with some DIY knowledge, easy to install. We supply fitting instructions upon delivery, if for any reason you need our friendly advice please telephone us and we will be able to talk through any difficulties you may be having.

Installation Service

On the other hand should you wish our teams of expert fitters to install your new shed, just select this option and we will contact you to arrange a convenient day for delivery and installation of your building. We usually give you an allocated am/pm time slot, so you do not have to wait in all day. Timber is a natural product, subject to changes caused by environmental conditions, to minimise contraction and expansion it is essential to maintain your building.

All timber sizes are nominal before machining unless stated.

All building dimensions shown are approximate based on external wall sizes, allowances should be made for roof overhangs, when locating your building in a confined space.

theshedcentre.com - Before you buy | The Shed Centre

Does shed floor need to be pressure treated?

Always use pressure treated lumber when constructing things that will need to stand up to the elements. As for the sheds' floor deck, use Â¾-in. or...

Last updated Oct 1, 2022