Photo: Angela Roma

How many footings do I need for a 12x12 shed?

How many footings do I need for a shed? There is no hard-and-fast answer, but a good rule of thumb (if using concrete foundation piers) is one shed footing every 8-10 feet.

siteprep.com - Shed Footings: The Complete Guide for 2022 - Site Prep

How do I keep water from coming through my stone foundation?

The drain tile (rigid or flexible pipe) is installed in the ground around the house. The drain tile is packed in stone, and loose dirt is placed on...

Last updated May 24, 2019

Do you need a building inspector for a garage conversion?

A garage conversion will most certainly need building regulations approval. You or your builder will need to stick to the Building Regulations when...

Last updated May 21, 2018

Can I build my own shed?

Yes, with the right plans you can build your dream shed.

Learn More »

Promotion

Footing Requirements for a Shed

1. Footing Requirements by Shed Size

This may be the single most important shed footing factor. Many local governments in our region divide sheds into the following size categories:

Less than 100 square feet

Sheds under 100 sq ft (or 200 sq ft in some locations) often require no footers whatsoever. Very small sheds like these have a low risk of sinking or buckling. Even if they do, any harm caused is likely to be insignificant. (A shed foundation can still increase the longevity of a small shed; you can read more about whether your shed needs a foundation here.)

Between 100 and 600 square feet

Sheds in this range often do not require “frost-proof” foundations but may be required to have a stone pad or shallow footers at 12” deep. For example, 12×16 shed foundation footers may not be required, but some type of gravel shed foundation would likely be advisable.

Over 600 square feet

Larger sheds like these typically require “frost protection”, aka shed footings that extend below the local frost line. Some locales make an exception to the footer depth requirement if the building is placed on a concrete slab.

2. Footing Requirements by Shed Wall Height

Height is another significant factor as it helps to determine how much weight the shed footers will be supporting per square foot. Note that for these purposes, shed heights are typically measured at the wall (or “eave”) height rather than the height at the roof peak. Sheds are often divided by height as follows:

Less than 10’ high

Sheds with walls under 10’ (or 12’ in some locales) may not require footings of any kind (although this is usually tied to a square footage requirement as well). If the shed includes a built-in floor, some municipalities allow them to be placed directly on a gravel pad.

Over 10’ high

Sheds over 10’ in height (or 12’ in some municipalities) often require footings of some type. Additionally, the local government may require both a zoning and construction permit for accessory buildings of this size. For example, barn shed footings would likely be required if the building contains a loft area or a second story.

3. Footing Requirements by Shed Utilities

Footings may be required if a building will be connected to any type of utility service. This includes electric, gas, oil, and/or sewer. In the photo above, an electrical conduit was installed as part of the shed footing/shed foundation installation; it will be connected to the shed when it is delivered. A utility connection can also affect whether a construction permit is required for the shed. This makes sense since the repercussions of a sinking shed are greater if it also runs the risk of rupturing or exposing a utility line.

4. Footing Requirements by Shed Use

If a shed will be used for habitation or any other human activity, shed footings may be required. In at least one case, a township noted that frost-depth shed footings were not required if “the building presents a low hazard to human life in the event of failure”. So if someone asks whether footers are necessary for an implement shed, the likely answer is “no”. However, shed footings are a good idea if an outbuilding will be used as a workshop, she shed, or office (as shown above). Here are links to shed footing regulations from several municipalities that you can refer to for ideas of what the typical requirements look like:

How much does it cost to build a decent shed?

Building a custom shed runs $60 to $150 a square foot, depending on the size and type of material, while having a shed assembled will cost $10 to...

Last updated Apr 7, 2021

What is the best state for a tiny home?

What are the Best States for Tiny Homes? #1 – Georgia. Northern Georgia's Blue Ridge mountains offer some of the most picturesque landscapes for...

Last updated Oct 6, 2022

Are shed plans easy to follow?

These are! They guide you every step of the way to complete your dream shed.

Learn More »

Promotion

What size wire do I need to run 40 amps 100 feet?

For a maximum of 40 amps, you'll need a wire gauge of 8.

Last updated Aug 11, 2020

Should a horse be stabled at night?

Horses can thrive with a combination of being stabled and having free rein of the pasture. Being pastured during the day and stabling your horse at...

Last updated Oct 23, 2019