Photo: ELEVATE

Should shed base have a fall?

Some landscapers may recommend putting a slope on the base for drainage, but the base itself needs to be completely level - the base does not necessarily have to be any larger than floor of the shed.

albanysheds.co.uk - Base Requirements - Albany Shed Co

What are the pros and cons of a pole barn house?

What are the Advantages of Building a Pole Barn Home? 1) Quicker Construction Timeline. 3) Superior Energy Efficiency. 4) An Open-Concept Floor...

Last updated Feb 12, 2021

Why do Japanese not shake hands?

Probably the most common cultural faux pas committed by foreigners in Japan is to grab someone's hand and give it a good old firm shake. This isn't...

Last updated Nov 12, 2019

Promotion

Base Requirements

We cannot stress enough the importance of putting your new Albany building onto a solid, flat, level foundation. Get it right and your building will fit together perfectly and last for years. Get it wrong and you could have problems with assembly, the shed will not last nearly as long and the doors may not close properly. Your local retailer may be able to offer a base-laying service or recommend someone who can.

Key Points You need a solid, flat, level base

You need sufficient room around the building for assembly and maintenance

You need to make sure you have suitable access for the panels to get to the base

Consider rainwater run-off

Floor plans are available for all of our standard models, which can sometimes help in constructing the base. Please specify on order if your base requires the direction of the floor joists to adhere to the floor plan as this can be subject to change

Suitable bases

We recommend paving slabs or concrete, especially for larger buildings. Some landscapers may recommend putting a slope on the base for drainage, but the base itself needs to be completely level - the base does not necessarily have to be any larger than floor of the shed. Paving slabs must be laid properly and not just put straight onto soil or grass. Decking is also usually suitable provided it is strong enough. On small to medium sized buildings, bearers / sleepers on a level gravel / shingle area can be suitable - see information on bearers below. A paving slab in each corner is not enough, even if they are level; the floor must be sufficiently supported throughout. Other examples of unsuitable bases include soil, grass, loose bricks, pallets, and any uneven surface.

Positioning of your building

Sizes listed are approximate and do not allow for roof overhang. It is normally best to allow plenty of room around the building - the minimum space required is usually 300mm (1ft) all the way around although 500mm is preferable. This is important and can make assembly easier as well as future re-treating and maintenance. Bear in mind the roofs do overhang the main body of the building so this must be taken into account, for example when a building is going into a more enclosed area. We understand that not everyone is looking to locate their shed in a large open area. With advice from us or your local retailer, usually a suitable solution can be found.

Bearers

We can supply bearers (timber posts) with your building if you wish to further raise the floor off the ground. If the floor of the shed is likely to come into contact with a lot of rainwater then bearers could significantly increase its life. The bearers would run in the opposite direction to the floor joists of the shed - if you are supplying your own bearers or sleepers then please check which way they will run and then specify on order that they must adhere to the stated direction as it can be subject to change. Normally bearers are not essential if you have a solid, flat, level base (other than for the reason previously mentioned), as the floor is on floor joists, which allow air underneath and keep the floorboards off the base. If your base is gravel / shingle then you should sit the shed on bearers / sleepers to give it a solid foundation and support the floor evenly. The gravel / shingle still needs to be level and shouldn't be too loose.

What is the best wood for a garden shed?

Any wood that combines beauty with outdoor durability is the ideal choice for exterior timber cladding for sheds, summerhouses and garden rooms....

Last updated Jul 13, 2019

Can I put new roof felt over old?

When felting over any old felt you can use a bitten primer to get a proper fix, some felts are also a 3 layer system allowing them to go over old...

Last updated May 21, 2022

Can I build my own shed?

Yes, with the right plans you can build your dream shed.

Learn More »

Promotion

Why does a shed door drop?

The most likely cause of a sagging shed door is that it has a lack of bracing and has not been built correctly in the first place. This is the...

Last updated Jul 27, 2018

What to put under gravel to prevent sinking?

Geotextile fabric will separate the rock layers from the gravel driveway from the soil below. When you decide to use this fabric, it will lengthen...

Last updated Apr 25, 2019

Can I build my own shed?

Yes, with the right plans you can build your dream shed.

Learn More »

Promotion

Does metal last longer than wood?

As you might expect – STEEL is definitely a stronger material than wood! It will last longer and withstand much more in terms of wind, snow loads...

Last updated Feb 19, 2020

Promotion

How do you stop a shed from wobbling?

If you know that moisture could be a problem, use blocks to elevate the wooden aspects of your shed. Poor craftsmanship can cause a shed to wobble....

Last updated Feb 3, 2021